Out of Stock
Condition: New
The Mr. Heater - DeWalt (DXH330) thermostatically controlled Electric heater operates at 3300 watts on a 240v single phase circuit. Constructed with dual coil supports oversized ergonomic handle and very durable jobsite construction.
Recessed controls provide protection for switches and knobs
Equipped with a 25°F-95°F thermostat. The heating element cycles on and off to maintain the set temperature
Designed and certified as an unattended source of jobsite heat
Heater coils are supported at both the top and bottom to reduce transport noise and provide extra support for increased coil life
Illuminated power switch with L.E.D. fault indicator to easily identify when the unit is powered on
Amps 14 A
Minimum Breaker Required 1-Pole 15 Amp
Output (BTU/HR) 11,250 BTU/HR.
Output (CFM) 250 CFM
Output (kW) 3.3 kW
Phase Single System 250v
Watts 3,300 W
Weight 19 Lbs.
The Mr. Heater - DeWalt (DXH330) thermostatically controlled Electric heater operates at 3300 watts on a 240v single phase circuit. Constructed with dual coil supports oversized ergonomic handle and very durable jobsite construction.
Recessed controls provide protection for switches and knobs
Equipped with a 25°F-95°F thermostat. The heating element cycles on and off to maintain the set temperature
Designed and certified as an unattended source of jobsite heat
Heater coils are supported at both the top and bottom to reduce transport noise and provide extra support for increased coil life
Illuminated power switch with L.E.D. fault indicator to easily identify when the unit is powered on
Amps 14 A
Minimum Breaker Required 1-Pole 15 Amp
Output (BTU/HR) 11,250 BTU/HR.
Output (CFM) 250 CFM
Output (kW) 3.3 kW
Phase Single System 250v
Watts 3,300 W
Weight 19 Lbs.
Mr F340640 Mr. Heater Dewalt (dxh330) 11260 Btu 3.3 Kw Forced Air Electric Construction Heater
